Table 2 MNBS texture and surface behaviors of the coatings Samples MNBS texture WCAs (degrees) WSAs (degrees) Continuous zone Discontinuous zone P1 AZD3965 ic50 coating Disordered nano-grass (500 nm in width) – 136 – P2 coating Well-ordered nano-fibers (5 to 10 μm in length/100

nm in width) Well-ordered nano-fibers (5 to 10 μm in length/100 nm in width) 170 0 to 1 Q1 coating Nano-scale spheres/papules (80 to 200 nm in diameter) Willow-like nano-scale segments (approximately 1 μm in length/100 to 500 nm in width) 158 – Q2 coating Nano-scale spheres/papules (60 to 150 nm in diameter) Nano-scale fiber segments (100 selleck compound to 500 nm in length/200 to 400 nm in width) 153 – Q3 coating Nano-scale spheres/papules (20 to 100 nm in diameter) Orderly nano-scale wires/bridges (1 to 8 μm in length/10 to 80 nm 3-deazaneplanocin A in width) 154 – Conclusions By disturbing crystallization during one-step coating-curing process, bionic lotus surfaces with controllable polymer nano-spheres/papules, nano-wires/fibers were firstly fabricated. It is demonstrated that both macroscopic force interference and internal microscopic force interference on polymer aggregates

under different cooling conditions will significantly affect the crystallization of polymer chains. Polymer chains stretched and elongated freely to form a disordered micro-nano-scale grass/leaf-like morphologies in pure PTFE coating (P1 coating), while orderly polymer nano-fibers (100 nm in length/5 to 10 μm in width) with a certain direction are obtained by the force F blow along the direction of H2 gas flow. During the quenching process in the uniform and non-uniform mediums, nano-papules/spheres (20 to 200 nm in diameter) formed in the continuous zone, while polymer aggregates are partially stretched to nano-fiber segments (1 μm in length/100 to 500 nm in width) during the crystallization process in the discontinuous zone. However, by polymer crystallization interference in the non-uniform medium, the polymer chains at discontinuous selleckchem zone of Q3 coating suffered much greater tensile force (F T) in comparison to Q1 and Q2 coating, which can be attributed to the temperature

difference between the continuous zone and discontinuous zone. The tensile force was large enough (F T> > F cr and ΣF T> > 0) to generate cracks and gaps in the discontinuous zone for Q3 coating. Therefore, nano-wires and nano-bridges (1 to 8 μm in length/10 to 80 nm in width) formed. We bring a novel perspective to controllable polymer nano-fibers; this study will provide a theoretical basis for polymer superhydrophobic surface with MNBS texture and promote development of polymer superhydrophobic surfaces in many engineering fields such as drag reduction and anti-icing. Acknowledgements The authors thank Chongqing Key Scientific and Technological Program Project (No. cstc2011ggC0037) and the ‘Western Light’ Talent Key Projects of the Chinese Academy of Sciences (No. 3ZR12BH010) for the financial support and Dr. Zakaria A. Mirza and Dr.