Selenomonas ruminantium, F succinogenes, and total bacteria were

Selenomonas ruminantium, F. succinogenes, and total bacteria were quantified using a LightCycler system (Roche, Mannheim, Germany) as described by Koike et al. (2007). Optimal PCR conditions for clade II of S. ruminantium were experimentally defined (annealing temperature for 62 °C and extension time for 15 s). Total DNA from ruminally incubated hay stems and whole rumen content obtained in a previous experiment (Koike et al., 2003a) were used as templates to monitor the changes in the abundance of S. ruminantium, F. succinogenes, and total bacteria over time. The details of these samples are as described by Koike et al. (2003a). In brief, orchardgrass hay stems in a

nylon bag were suspended in sheep rumen, and samples were periodically withdrawn (at 10, 60, and 120 min, and PLX4032 6, 14, 24, 48 and 96 h) and rinsed. Whole rumen content was also periodically taken (at 0, 2, 6, 14, and 24 h after feeding). Both in sacco and in vivo samples (n = 3) were stored at −80 °C until DNA extraction. The abundance of clade I was estimated by subtracting the assay value of clade II from the species (S. ruminantium)-specific assay value, for which primers for the species-specific

assay had been confirmed to amplify clade II bacteria. All assay values were expressed as copy numbers of bacterial 16S rRNA gene g−1 sample. Data of bacterial adhesion, acid production, and fiber digestion were subjected TSA HDAC order to anova followed by the Tukey–Kramer test using the GLM procedure of SAS (1989). Comparison of mean value between two clades was made by Student’s t-test. Statistical significance was defined as P < 0.05.

Of 154 Gram-negative curved rods recovered from roll tubes, 19 isolates were identified as S. ruminantium and its relatives based on their 16S rRNA sequences. These isolates were classified into two clades (I and II) (Fig. 1). Clade I comprised 13 novel isolates obtained in the present study, together with the S. ruminantium type strain GA192 and other 21 known isolates of S. ruminantium. The sequence similarity these within this clade I ranged from 93.8% to 99.7%. Although branching of clade II from clade I was not supported by a bootstrap value (< 80%), clade II comprised six novel isolates found in the present study, a previously cultured rumen bacterium (RC-11) and three uncultured bacteria, and the sequence similarity within the clade II ranged from 95.6% to 98.4%. Clade I isolates obtained in the present study showed high sequence similarity (97.5–99.2%) with known isolates of S. ruminantium, while clade II isolates shared a low sequence similarity (93.6–94.9%) with those isolates (Table 1). All isolates produced propionate and acetate as the main metabolites, while the presence and activity of fibrolytic enzymes (CMCase and xylanase) differed among isolates and even within clades (Table 1). Ten of 14 isolates of clade I displayed CMCase activity, while all six isolates of clade II lacked this enzyme or exhibited low activity.

Comments are closed.